Drying a structure correctly isn't about running a few fans and hoping — it's a calculated process based on temperature, humidity, and airflow readings.
Our New Market, AL drying plans start with thermal imaging to map exactly where moisture is hiding.
We calculate drying requirements using temperature and humidity data, not a flat per-room rule.
Low Grain Refrigerant dehumidifiers pull significantly more moisture from the air than consumer-grade units.
We map hidden moisture with thermal imaging before finalizing equipment placement.
Daily logs give you and your insurer verifiable proof of progress, not a technician's word.
Here's the full scope of a Structural Drying And Dehumidification job in New Market, from initial scan to final verification.
The assessment sets the baseline every later reading gets measured against.
We map the full extent of moisture intrusion before placing a single air mover.
Equipment is placed according to calculated airflow paths, not an even spread across the room.
Documented logs track the numbers from day one through final verification.
We adjust drying speed for sensitive materials like hardwood and cabinetry to prevent secondary damage.
Final verification compares closing readings against the material-specific dry standard, not a general guess.
A quick call helps us determine whether thermal imaging and full drying equipment are needed.
A technician arrives with thermal imaging cameras and moisture meters ready to assess.
You'll see the calculated plan and cost before drying equipment goes down.
We verify final moisture readings against dry standard before removing equipment.
"The thermal imaging found moisture behind a wall that looked completely fine from the outside. Would have missed it otherwise." — Julian R.
"They came back every single day to take readings and showed me the numbers improving. Felt like real science, not guesswork." — Monique T.
"Our hardwood floor didn't warp because they slowed the drying process down specifically for it." — Grant P.
We rely on moisture meters and thermal imaging, not appearance alone.
Psychrometrics uses scientific formulas to size the drying plan to the actual moisture load.
Typical drying time is 3-5 days for standard materials, longer for sensitive ones like hardwood.
You'll see the actual numbers improve each day through documented logs.
Yes, we use slower, controlled drying specifically calibrated for hardwood to prevent warping.
We treat flat readings as a signal to recalculate, not something to wait out.
If your property is in or near New Market, a crew can typically respond the same day.
One call starts the psychrometric assessment process.
Call +1-844-833-1325